White Wedding Card

Materials:

Mod Florentine label
Mod Wedding Flowers sticker sheet
white and gold Design Line stickers
soft pink paper
tobacco leaf paper
glue stick
foam mounting tape
scissors
8-1/2" x 11" of white cardstock - scored and folded in half

Steps:

1. Cut piece of tobacco paper to 5" x 6-1/2" rectangle. Center tobacco paper on the outside front of the white card and adhere firmly using a glue stick.
2. Cut soft pink paper to a 3" x 4-1/2" rectangle. Center soft pink paper on top of tobacco paper and adhere firmly using a glue stick.
3. Peel off the thin white and gold Design Line sticker and place it along the top edge of the pink paper, corner to corner. Repeat this step until the entire edge of the pink paper is framed by the sticker. The sticker should overlap at each corner. Miter the corners of the gold line sticker by cutting each sticker end at a 45-degree angle using a craft knife. Discard the tiny pieces of sticker.
4. Adhere the Florentine label to the center of the pink paper.
5. From the Wedding Flowers motif stickers, remove the flower stickers and stick them together to create a single sticker floral arrangement. Tuck the single pink rose stems behind each end of the bouquet.
6. Cut and place four small pieces of mounting tape, sticky side up, on the back of the bouquet of flower stickers. Don't remove backing from mounting tape. Dust the back of the sticker bouquet with baby powder. Blow away excess powder.
7. Remove the mounting tape backing from each piece of mounting tape. Center and adhere the floral bouquet sticker on top of the Florentine label. The mounting tape adds a bit of dimension to the card.